Alarm Recording - Sanyo DSR-3016P Manual For Remote Operation

Manual for remote operation by network connection
Hide thumbs Also See for DSR-3016P:
Table of Contents

Advertisement

ALARM RECORDING

This specifies whether alarm recording will be
carried out or not, and sets the recording cycle and
recording conditions when alarm recording is carried
out.
1
Select an alarm recording mode from the
[ALARM RECORDING] menu
(Default setting: OFF).
• OFF:
No alarm recording will be carried out.
• ENABLED: Alarm recording is carried out at any time,
without regard to timer recording (timer
settings).
• AL-REC ON TIMER:
Alarm recording is only carried out during
timer recording.
• AL-REC OFF TIMER:
Alarm recording is only carried out at
times other than during timer recording.
• OLY AL-RC ON TMR:
During the time set by the timer, the only
recording carried out is alarm recording,
not timer recording.
2
Select the alarm recording method from the
[ALARM INTERLEAVE] menu.
(Default setting: ONLY)
• ONLY :
Only the camera where the alarm was
triggered is recorded.
• SW:
The images from the camera where the alarm
was triggered and the images from the
cameras specified by the PROGRAM GROUP
setting are recorded alternately.
3
Specify the program for recording camera
images from the [PROGRAM GROUP] menu.
(See p. 9)
OFF:
No program group is specified and all camera
images are recorded.
P-1:
Specifies program No. 1.
P-2:
Specifies program No. 2.
P-3:
Specifies program No. 3.
P-4:
Specifies program No. 4.
(Default setting: OFF)
4
Select the recording cycle from the [REC RATE]
menu.
A 50, A 25, A 16.67, A 12.5, A 8.333, 6.25, 5, 4.167, 3.571,
3.125, 2.778, 2.5, 2.273, 1.923, 1.667, 1.471, 1.316, 1.190,
1.087, 1, 0.5, 0.333, 0.25, 0.2, 0.1, 0.05, 0.033 (Units: FPS)
(Default setting: A 25 FPS)
5
Set the duration for alarm recording from the
[DURATION] menu.
5 SEC, 10 SEC, 20 SEC, 40 SEC, 1 MIN, 2 MIN, 3 MIN,
4 MIN, 5 MIN, 10 MIN, 15 MIN, CC, INDIV.
(Default setting: 5 SEC)
The alarm recording duration can be set
separately for each camera. If you select [INDIV.]
from the [DURATION] menu, alarm recording is
then carried out for each camera for the duration
of time that has been set using the [ALARM
DURATION SET] menu that is described later on.
(See p. 18)
Menu Setting Procedures
16
English

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dsr-3009p

Table of Contents