Table of Contents
Advertisement
Settings
To use the functions of this unit effectively, the recording conditions and installation environment
must be specified beforehand. These setting items are arranged and displayed in two levels
consisting of the main menu and sub-menus.
Refer to the setting procedures for each menu on the following pages for details on the various
setting methods.
I I I I Menu Selection Method
1
Click the R button on the operating panel to
display the [MAIN MENU] screen.
2
When the specified menu on the [MAIN MENU]
screen is selected and clicked, the sub-menu will
be displayed.
3
Change the required settings from the sub-menu
screen.
4
To clear the menu screen, click the Playback
mode P button on the operating panel to leave
the menu screen and display the live screen.
I I I I Menu Configuration
Recording
1. CLOCK SET
conditions
2. SUMMER TIME SET/
EXT. CLOCK SET
3. PROGRAM REC SET
4. RECORDING AREA SET
5. RECORDING CONDITIONS SET
6. NORMAL REC MODE SET
7. TIMER SET
8. HOLIDAY SET
9. ALARM REC MODE SET
10. ALARM DURATION SET
Installation
11. DISPLAY SET
environment
12. RS-232C/RS-485 SET
13. BUZZER SET
14. NETWORK SET
15. HDD SET
16. POWER FAILURE/USED TIME
*
Shaded items are for information display only.
English
Main menu
• SUMMER TIME SET • EXT. CLOCK SET
• TOTAL CAPACITY • RECORDING AREA CAPACITY
• AREA FULL RESET
• NORMAL RECORDING AREA OVERWRITE
• ALARM RECORDING AREA OVERWRITE
• REMAINING DISK WARNING
• PICTURE QUALITY • AUDIO RECORDING
• REC RATE • REC PROGRAM GROUP
• PICTURE QUALITY • AUDIO RECORDING
• ALARM RECORDING
( REC MODE, PROGRAM GROUP, REC RATE, DURATION)
• PRE-ALARM RECORDING (REC RATE, DURATION)
• ALARM TRIGGER
• DATE • TIME • QUALITY • REC RATE
• ALARM COUNT • ALARM TYPE
• CONTROL • DATA SPEED • STATUS INFO
• ALARM INFO • ADDRESS
• ALARM • DISK FULL • DISK ERROR
• LOCK WARNING • KEY IN • NON REC
• IP ADDRESS • SUBNET MASK • GATEWAY • PORT
• PASSWORD SETTING • NETWORK SPEED
• DISK CAPACITY • MIRRORING
• PLAYBACK DRIVE
• POWER FAILURE • USED TIME • FIRMWARE
• Because entry from playback mode is not
possible, click the stop button to return
temporarily to live mode and then click the R
button.
• You must be connected at the ID3 user level in
order to change settings.
• If the main unit is recording, the menu details
can be checked but the settings cannot be
changed.
• When moving from one sub-menu to another
sub-menu, first click the R button to return to
the main menu.
Sub-menu
7
Reference
page
8
8
9
10
11
12 to 13
14
15
15 to 17
18
18
19
19
20
21
21
Advertisement
Table of Contents
