Alarm Recording; Normal Recording Easy Setup - Sanyo DSR-5016P Quick Manual

3 RECORDING

Alarm recording

Use the following procedure to record alarm video when an
alarm signal is detected.
1
Set alarm recording. ( INSTRUCTION
MANUAL, "Setting alarm recording",
P.93)
2
When an alarm signal is detected
When an alarm signal is detected, "ALARM" flashes in the
operation display and alarm recording starts (indicated by
"REC".)
Whenever an alarm occurs, the number of alarms
indicated in the operation display is incremented.
01-01-05 00:00:00 REC REPEAT EN A ALARM 0000001
02
If an alarm occurs during normal recording or timer
recording, recording ends.
A maximum of 1,000,000 alarm recordings can be made
on one hard disk. The number of maximum recordings can
be increased to 6,000,000 by expanding the optional hard
disk. However, the maximum number of recordings is
affected by set recording conditions. Be sure to check the
menu settings and display content.
3
End alarm recording.
When the alarm duration has expired (default setting: 20
seconds), both "REC" and "ALARM" stop flashing on the
operation display and recording stops.
Be sure to set the time when using the digital video
recorder for the first time. Recording is not possible until
the time is set. ( P.5)
When alarm recording total exceeds 1,000,000 and
"OVERWRITE" on the <RECORDING CONDITIONS SET>
screen is set to "ON", older recordings are overwritten even
if the hard disk has remaining memory capacity.
Alarm recording is not performed when "OFF" is set.
When "OVERWRITE" on the <RECORDING
CONDITIONS SET> screen is set to "OFF" and the space
remaining in the recording area becomes insufficient, the
FULL indicator begins to flash. If recording is continued
beyond this point, the recording area becomes full and
recording stops. Perform AREA FULL RESET to enable
recording. ( INSTRUCTION MANUAL, P.79)
English
Counts the number
of alarms.
Displays up to
9999999.
After 9999999, the
counter returns to
0000000 and
resumes counting
from 1.
11

Normal recording easy setup

Use the following procedures to make simple recording
settings. Two different setting methods may be used -- one
based on recording days; the other based on recording rate.
1
Set normal recording easy setup.
(1) Select "1. NORMAL REC EASY SET" from the
<RECORD SET>.
(2) Select "RECORDING DURATION BASE" to make
settings based on recording days; select "REC RATE
BASE" to make settings based on recording rate.
(3) The setting screen is displayed. See INSTRUCTION
MANUAL for more details on setting.
RECORDING DURATION BASE
REC RATE BASE
2
Press the [EXIT/OSD] button.
The setting procedure is ended and the display returns to the
normal screen.
EXIT/OSD
<RECORDING DURATION BASE>
RECORDING DURATION : -- DAYS
TIMER RECORDING(DLY) : OFF
START --:-- STOP --:--
PICTURE QUALITY : ENHANCED
AUDIO RECORDING : OFF
NUMBER OF CAMERAS : 2
REC RATE : ---- FPS/CAM
<REC RATE BASE>
REC RATE : ---- FPS/CAM
TIMER RECORDING (DLY) : OFF
START --:-- STOP --:--
PICTURE QUALITY : ENHANCED
AUDIO RECORDING : OFF
NUMBER OF CAMERAS : 1
RECORDING DURATION : ---- DAYS