Table of Contents
Advertisement
3
RECORDING
Alarm recording
Use the following procedure to automatically record alarm
video to the alarm recording area when an alarm signal is
detected.
1
Set alarm recording.
Set "7. ALARM REC MODE SET" from <RECORD SET>.
(See INSTRUCTION MANUAL.)
2
Press the [EXIT] button.
The setting procedure is ended and the normal screen is
displayed.
EXIT
When an alarm signal is detected
When an alarm signal is detected, "ALARM" flashes in
the operation display and the alarm recording starts
(indicated by "REC").
Alarm video is recorded to the alarm recording area.
Whenever an alarm occurs, the number of alarms as
indicated in the operation display is incremented.
01-01-04 00:00:00 REC REPEAT EN A ALARM 0000
02
If an alarm occurs during normal recording or timer
recording, the recording operation will be ended.
3
End alarm recording.
When the alarm duration has expired (default setting: 20
seconds), both "REC" and "ALARM" finish flashing from
the operation display and recording stops.
Counts the number
of alarms.
8
When the space remaining in the alarm recording area
drops below a preset value, the FULL indicator on the
digital video recorder's front panel starts to flash. If
recording is continued beyond this point, the alarm
recording area will become full, recording will stop, and
the FULL indicator will stop flashing and remain lit. In
such a case, use the <RECORDING AREA SET> menu
to perform "AREA FULL RESET" for the alarm
recording area, thus allowing recording to start again
from the beginning. (See INSTRUCTION MANUAL.)
English
Advertisement
Table of Contents
