Switching On And Setting Up - Pioneer DVR-LX61D Operating Instructions Manual

Getting started
04
Chapter 4
Getting started

Switching on and setting up

When you switch the recorder on for the first
time, you can make several basic settings
using the Setup Navigator feature. This takes
you through setting the clock, the internal TV
tuner and the video output.
If you're using the recorder for the first time,
we strongly recommend you use the Setup
Navigator before starting to use the
recorder.
1 Switch on your TV and set the video
input to this recorder.
STANDBY/ON
2 Switch on the recorder.
When you switch on for the first time, your TV
should display the Setup Navigator screen (If
the Setup Navigator doesn't appear, you can
also access it from the Initial Setup menu;
see page 137).
• If this recorder is connected to a
compatible TV using a fully-wired 21-pin
SCART cable, the recorder will take a few
seconds to download country, TV screen
size and language information. (Check
the manual that came with your TV for
compatibility information.)
ENTER
3 Choose a language (then press
ENTER).
Initial Setup
Basic Basic
Digital Tuner
Analog Tuner
Video In/ O ut
Audio In
Audio O ut
Language
Recording
This will also set the audio, subtitle and DVD
menu language preferences.
Note
1 If the recorder does not accept the On or Auto setting (the highlight jumps back to Off), check that the antenna
32
is properly connected and that it is not shorted, then try making the setting again.
En
Clock Setting Language
Input Line System
Pow er Save
HELPp
EPG Type Select avig ator a or
Setup N
4 Start the Setup Navigator.
ENTER
k Setting
Complete this setup before you
t Line System
start using your recorder.
er Save
Start Start
P
Cancel
p Navigator p Navigator
Please use the Initial Setup if you
want to make more detailed settings.
• If you don't want to use the Setup
Navigator, press  to select Cancel,
then press ENTER to exit the Setup
Navigator.
ENTER
5 Select an Aerial Power setting
for the built-in digital tuner.
• On: power is always supplied to the
connected aerial, whether the recorder
is on or in standby.
• Auto: power is only supplied when this
recorder is on.
• Off: power is never supplied to the
aerial.
ENTER
6 Select 'Auto Scan' to start
scanning for D.TV channels.
• Select Do not set if you want to skip
D.TV channel setup (because they have
already been set up, for example), then
skip to step 8 below.
• You can go back to the previous screen
in the Setup Navigator by pressing
RETURN/EXIT.
ENTER
7 Select your country.
The recorder starts scanning for new
channels. After the scan is complete the
recorder will let you know how many new
channels were found.
1