Rear Panel Connections - Pioneer DVR-LX61D Operating Instructions Manual

Connections
02
Chapter 2
Connections

Rear panel connections

1 2
AUDIO VIDEO
R L
ANTENNA
IN
OUT
Y P
B
COMPONENT VIDEO OUT
7
1 ANTENNA IN (RF IN)/OUT
Connect your TV antenna to the ANTENNA
IN (RF IN) jack. The signal is passed through
to the ANTENNA OUT jack for connection to
your TV.
2 INPUT 3
Stereo analog audio, video and S-Video
inputs for connection to a VCR or other
source component.
3 AV2 (INPUT 1/DECODER) AV
connector
Audio/video input/output SCART-type AV
connector for connecting to a VCR, or other
equipment with a SCART connector. The
input accepts video, S-Video and RGB. See
AV2/L1 In on page 140 for how to set this up.
4 LAN (10/100)
Ethernet port for 10BASE-T (10 Mbps)/
100BASE-TX (100 Mbps) network connection
(page 25).
5 HDMI OUT
HDMI output for high quality digital audio
and video.
6 DIGITAL AUDIO OUT (COAXIAL)
Coaxial digital audio jack for connecting to
an AV amplifier/receiver, Dolby Digital/DTS/
MPEG decoder or other equipment with a
digital input.
7 COMPONENT VIDEO OUT
A high-quality video output for connecting to
a TV or monitor with a component video
14
input.
En
3
S-VIDEO
INPUT 3
AV 2 (INPUT 1/DECODER)
G-LINK
P
R
AV 1 (RGB) – TV
OUTPUT
8 9 10 11
4 5
LAN(10/100)
HDMI OUT
5 V 30 mA
IN OUT
IN
CONTROL
ANTENNA(DIGITAL)
12
8 OUTPUT
Stereo analog audio, video and S-Video
outputs for connection to a TV or AV
amplifier/receiver.
9 AV1 (RGB)-TV AV connector
Audio/video output SCART-type AV
connector for connecting to a TV or other
equipment with a SCART connector. The
video output is switchable between video,
S-Video and RGB. See AV1 Out on page 140
for how to set this up.
10 G-LINK™
Use to connect the supplied G-LINK™ cable
to enable GUIDE Plus+
external satellite receiver, etc.
11 CONTROL IN
Use to control this recorder from the remote
sensor of another Pioneer component with a
CONTROL OUT terminal and bearing the
Pioneer  mark. Connect the CONTROL
OUT of the other component to the
CONTROL IN of this recorder using a mini-
plug cord.
12 ANTENNA (DIGITAL) IN/OUT
Connect your DTV antenna to the ANTENNA
(DIGITAL) IN jack. The signal is passed
through to the ANTENNA (DIGITAL) OUT
jack for connection to your TV.
13 AC IN – Power inlet
Connect to a power outlet using the supplied
power cable after making all other
connections.
6
COAXIAL
DIGITAL OUT
®
to control an
AC IN
13