Front Panel Displays - Pioneer DVR-LX61D Operating Instructions Manual

Additional information
19
Message
• You are not allowed to watch this
Conditional Access Programme.
• There is no DV input or the input
signal is unrecordable.
• No DV camcorder connected.
• You cannot connect more than one
DV camcorder at a time.
• Cannot operate the DV camcorder.
• Could not operate the DV camcorder.
• The DV camcorder is not set for
playback. Please select playback mode
on the DV camcorder.
• The printer is not ready or is not
connected. Please check the printer.
• Printing has been cancelled
because ...

Front panel displays

The table below shows a list of error messages that you may encounter when using the
recorder and an explanation of their meaning.
Message Explanation/Action
• E01 The HDD may be damaged or broken. Please ask your nearest Pioneer-authorized
service center or your dealer to carry out repairs.
As the HDD info cannot be properly read, no new recordings can be made. Reinitializing
• E02
the HDD (page 132) may result in your being able to make recording again. Note that
reinitializing the HDD will erase all recorded contents, including protected files.
166
En
Explanation/Action
A CA module or smart card (obtained from your
service provider) is required to watch the selected
programme. Insert the supplied module or card
into the Common Interface card slot on the front
panel of the recorder (page 27).
No signal was detected at the DV IN jack. This may
appear if a blank section of DV tape is playing in
the connected camcorder.
The camcorder is not connected properly, or the
camcorder is switched off.
This recorder's DV jack supports connection to
just one camcorder.
This recorder cannot operate the DV camcorder.
Try switching off the camcorder then turn it back
on again.
This recorder was not able to operate the DV
camcorder.
The camcorder is in camera mode. Switch it to
playback mode.
This message is displayed when communication
could not be established with the printer. See the
Troubleshooting section if you do not know the cause.
This message is displayed when there is a printer
error during printing. After checking the printer for
the cause of the error, either reconnect the printer
and start the printing job again, or select "Yes" to
resume printing (select "No" to cancel the print
job). See also the operating instructions that came
with your printer for possible causes of print errors.