Working - Pioneer DVR-LX61D Operating Instructions Manual

Additional information
Network
Problem
Cannot connect to
network
The Connect PC
function does not work
properly with an
Ethernet connection
If the unit does not operate normally due to external effects such as static electricity, disconnect
the power plug from the outlet and insert again to return to normal operating conditions.
If the picture freezes and the front panel and remote control
buttons stop working
• Press  (Stop) then try restarting
playback.
• Press the front panel  STANDBY/ON
button to switch the power off, then
switch back on and restart playback. If
the power fails to switch off, press and
hold  STANDBY/ON for five seconds
until the power switches off.
Remedy
• Turn this unit's power off and on again.
• Check that the LAN cable is properly connected.
• Check that the router's power is turned on.
• Check that the IP address is properly set.
• Either turn the router's DHCP server function on or change the
Network settings according to the environment (page 147).
• On the PC, click 'Start', 'Network', and then 'Network and Sharing
Center' on the command bar. When the 'Network and Sharing Center'
window appears, ensure that 'Network discovery' under the 'Sharing
and Discovery' section is enabled.
• From 'Network' on the PC, right-click the 'Pioneer.HDD/DVD-
Recorder' icon and select 'Uninstall'. A comfirmation message may
appear. In this case, press 'Continue'. Wait at least 30 seconds, then
reconnect the PC using the procedure described at Ethernet
connection on page 125.
• Normal operation may be unavailable if the connected equipment
has Internet security software installed in it.
STANDBY/ON
HDD/DVD
HDD DVD
STANDBY/ON
DV IN USB
OPEN/CLOSE
COMMON INTERFACE
STOP REC
INPUT
CH
SELECT
19
163
En