Pioneer DVR-LX61D Operating Instructions Manual page 165

Additional information
Message
• Repairing disc.
• Repairing the HDD.
• Could not repair the disc.
• Overheating has stopped operation.
Press DISPLAY to clear message.
• HDD optimization is recommended.
This can be done using Disc Setup.
• Please perform HDD optimization.
This can be done using Disc Setup.
• The HDD has not been sufficiently
optimized. Please optimize again.
• An error occurred. Please consult the
service center. Note that contents on
the HDD may be erased when servicing
this unit.
• The Hard Disk Drive info is incorrect.
Use the Disc Setup menu to reinitialize.
• This signal's TV system is different
from the recorder's setting.
• Recording failed due to a TV system
mismatch. Press DISPLAY to clear
message.
• Playback has stopped because the TV
system is different than the recording.
Explanation/Action
During recording, the power was cut. This display
appears when the power is restored.
The recorder was unable to repair the disc after a
power cut. The contents of the recording will be
lost.
The internal temperature of the recorder has
exceeded the operating limit. If this message
reappears, please ask your nearest Pioneer-
authorized service center or your dealer to carry
out repairs.
The HDD should be optimized (basically, HDD
housekeeping) to maintain playback and recording
performance.
The HDD is in more urgent need of optimization in
order to maintain performance.
If this message appears repeatedly after
optimizing the HDD it is likely that there is not
enough free space on the HDD for optimization to
complete properly. Please erase some titles from
the HDD and optimize again.
This message is displayed when information from
the HDD cannot be read. The HDD may be
damaged or broken. Please ask your nearest
Pioneer-authorized service center or your dealer to
carry out repairs.
As the HDD info cannot be properly read, no new
recordings can be made. Reinitializing the HDD
(page 132) may result in your being able to make
recording again. Note that reinitializing the HDD
will erase all recorded contents, including
protected files.
The TV system (PAL, NTSC, etc.) of the current
channel is different from the TV system settings of
this recorder.
The timer recording failed because the TV system
of the channel set for recording was different from
the setting of the recorder.
During recording or timer recording standby, the
TV System (PAL, NTSC, etc.) of the playback video
changed, causing playback to stop automatically.
19
165
En