Receiver - Pioneer DVR-LX61D Operating Instructions Manual

Connections
1 Connect the VIDEO OUTPUT jack to a
video input on your TV.
Use the yellow jack of the supplied audio/
video cable for the video connection.
2 Connect the AUDIO OUTPUT jacks to
the corresponding audio inputs on your
TV.
Use the red and white jacks of the supplied
audio/video cable for the audio connection.
Make sure you match up the left and right
outputs with their corresponding inputs for
correct stereo sound.
Using the S-Video or component
video output
To component
video input
To audio
input
TV
2
S-VIDEO
AUDIO
OUTPUT OUTPUT
AUDIO VIDEO
R L
ANTENNA
IN
S-VIDEO
INPUT 3
AV 2 (INPUT 1/DECODER)
G-LINK
OUT
Y P P
B R
AV 1 (RGB) – TV
COMPONENT VIDEO OUT OUTPUT
COMPONENT
VIDEO OUT
1 Connect the S-Video or component
video output to a similar input on your
TV.
For an S-Video connection, use an S-Video
cable (not supplied) to connect the S-VIDEO
OUTPUT jack to an S-Video input on your TV.
For a component video connection, use a
component video cable (not supplied) to
connect the COMPONENT VIDEO OUT
jacks to a component video input on your TV.
See also Component Video Out on page 139
for how to set up the component video
output for use with a progressive scan-
compatible TV.
Note
1 The diagram shows SCART video connections, but you can alternatively use any of the other audio/video
connections.
To video
input
1
COAXIAL
LAN(10/100)
AC IN
DIGITAL OUT
HDMI OUT
5 V 30 mA
IN IN OUT
CONTROL
ANTENNA(DIGITAL)
2 Connect the AUDIO OUTPUT jacks to
the corresponding audio inputs on your
TV.
You can use the supplied audio/video cable,
leaving the yellow video plug disconnected.
Make sure you match up the left and right
outputs with their corresponding inputs for
correct stereo sound.
Connecting to a cable box or
satellite receiver
If you have a cable box or satellite receiver
with a built-in decoder, connect it to this
recorder and your TV as shown on this
1
page. If you are using a separate decoder
box for your cable/satellite TV, set up
following the instructions on the next page.
Using the setup on this page you can:
• Record any channel by selecting it on
the cable box, satellite receiver or digital
terrestrial receiver.
• Change channels and set timer
recordings on the external receiver using
®
the GUIDE Plus+
G-LINK™ cable, and after setting up).
Important
• Do not connect this recorder to your TV
'through' your VCR, satellite receiver or
other component. Always connect each
component directly to your TV or AV
amplifier/receiver.
• When using the GUIDE Plus+ system to
make a timer recording from an external
receiver, make sure that the external
receiver is switched on.
system (via the
02
17
En