General Information; Diagnosis; Cprm Id Number And Data Setting - Pioneer dvr-3100-s Service Manual

5

7. GENERAL INFORMATION

QQ
3 7 63 1515 0

7.1 DIAGNOSIS

7.1.1 CPRM ID NUMBER AND DATA SETTING

Use DVD Recorder DATA DISC [GGV1134] and Service Remote Control Unit [GGF1381]
Entering the ID Number and ID Data for DVD Recorder
For the DVD recorder,it is necessary with the recoding/playback of DVD–RW disc to set an individual number (ID number) and ID data to
each recorder. If the number and data are not set correctly with the following procedure, operations in the future may not be guaranteed.
You will find the ID number to be set on the ID label on the rear panel.
Important: If no ID label is found on the rear panel, write down the specified ID number by checking it according to "How to
confirm the ID number" shown below.
The Input is Necessary When:
• " CPRM ERR" is displayed on the FL display immediately after the power is turned on or in Stop mode.
• When the MAIN ASSY , DRIVE ASSY or the FLASH ROM is exchanged.
Note:
Be sure to enter the ID number in Stop mode.
Use the service remote control (GGF1381) for operations. Only opening/closing of the tray are performed from the player.
The ID data disc is swept out automatically after the recorder has read the data from it.
How to Input the ID Number and ID Data
1 To enter the input mode, press ESC + STEREO sequentially in
a status with no ID number set, such as after FLASH-ROM
downloading.
2 As number input is enabled when the unit enters the input
TE
L 13942296513
mode, input the 9-digit ID number.
(The entered number is also displayed on the FL display.)
[Recorder's ID Number Setting]
ID Number ?
> - - - - - - - - -
2
<CLEAR> Exit
Input ID Number !
3 After inputting the number, press SEARCH to register the ID
number.
[Recorder's ID Number Setting]
ID Number ?
> 0 0 0 0 0 0 0 0 1 OK ?
<PLAY>
<SEARCH> Enter
3
Input ID Number !
www
.
5
http://www.xiaoyu163.com
6
Compare Mode
x ao u163
y
i
6
http://www.xiaoyu163.com
7
2 9
8
4 When the ID number has been registered, the unit enters the ID
data input mode. (The FL display indicates "INSERT ID.")
In this condition, place the ID data disc on the tray and close the
tray using the CLOSE key "7/0" on the player.
[Recorder's ID Data Setting]
Q Q
3 6 7 1 3 1 5
<CLEAR> Exit
Insert The ID Data Disc !
4
5 While the data are being read, the message shown in the figure
at left is displayed on the screen.
(The FL display indicates "LOAD ID.")
[Recorder's ID Data Setting]
Loading The ID Data Disc !
5
co
.
DVR-3100-S
7
9 4 2 8
0 5 8 2 9 9 4 2 8
m
8
9 9
A
B
C
9 9
D
E
F
73
8