Agb1500_Self_Test - Agilent Technologies B1500A User Manual

Table 2-9
NOTE
Syntax
Parameters
SCUU Input Output Connection Control
path
1
2
3
4
where, MFCMU will be installed in the slot numbered slot. Then, Force1/Sense1 is
connected to the SMU installed in the slot numbered slot-1. And Force2/Sense2 is
connected to the SMU installed in the slot numbered slot-2.
To use SCUU
Before turn the Agilent B1500 on, connect the SCUU to the MFCMU and two
MPSMU/HRSMUs properly. The SCUU is used to switch the module (SMU or
MFCMU) connected to the DUT.

agb1500_self_test

This function causes the instrument to perform a self-test and returns the result of
that self-test. This is used to verify that an instrument is operating properly. A failure
may indicate a potential hardware problem.
ViStatus _VI_FUNC agb1500_self_test(ViSession vi, ViPInt16 test_result,
ViChar_VI_FAR test_message[ ] );
vi Instrument handle returned from agb1500_init( ).
test_result Numeric result from self-test operation. Returned data. If no
error is detected, 0 is returned.
test_message[ ] Self-test status message.Returned data. Up to 256 characters.
Agilent B1500 VXIplug&play Driver User's Guide, Edition 3
SCUU output connection after the function
CMUH/Force1/Sense1
Force1/Sense1
Open
Force1/Sense1
CMUH
Driver Functions
agb1500_self_test
CMUL/Force2/Sense2
Open
Force2/Sense2
Force2/Sense2
CMUL
2-45