Ret = Agb1500_Setadc; Ret = Agb1500_Setadctype(Vi, Agb1500_Ch_All, Agb1500_Hspeed_Adc); Ret = Agb1500_Resettimestamp(Vi) - Agilent Technologies B1500A User Manual

Programming Examples for Visual Basic Users
Pulsed Sweep Measurement
ret = agb1500_setAdc(vi, agb1500_HSPEED_ADC,
agb1500_INTEG_MANUAL, smpl, agb1500_FLAG_OFF)
ret = agb1500_setAdcType(vi, agb1500_CH_ALL,
agb1500_HSPEED_ADC)

ret = agb1500_resetTimestamp(vi)

check_err vi, ret
ret = agb1500_force(vi, m(2), agb1500_VF_MODE, 0, 0, 0.05, 0)
Dim d_ib As Double
If nop2 = 1 Then
d_ib = 0
Else
d_ib = (ib2 - ib1) / (nop2 - 1)
End If
Dim ibo As Double
ibo = ib1
i = 0
Line
47 to 48 Sets the high speed ADC, and selects it for all measurement
channels.
49 Resets time stamp.
50 Calls the check_err subprogram (shown in Table 3-1) to check if
an error status is returned for the previous line.
52 Applies voltage to device.
54 to 59 Declares a variable, and defines the value. This variable is used
for the step value of the secondary sweep source.
61 to 62 Declares a variable, and defines the value. This variable is used
for the output value of the secondary sweep source.
64 Sets the array counter i to 0.
3-46 Agilent B1500 VXIplug&play Driver User's Guide, Edition 3
'secondary sweep step value (delta)
'secondary sweep source output
'array counter for sweepIv returned data
Description
'47
'50
'54
'59
'61