Agb1500_Setiv - Agilent Technologies B1500A User Manual

Syntax
Parameters
Syntax
NOTE
Parameters
b. Output voltage slew rate becomes 1/2 of the rate when starting the settling
detection.
The condition b means that the quasi-pulse source applies the voltage close to the
measurement voltage.
ViStatus _VI_FUNC agb1500_setIleak(ViSession vi, ViInt32 channel,
ViReal64 range, ViReal64 voltage, ViReal64 compliance, ViReal64 start, ViReal64
hold, ViReal64 delay);
vi Instrument handle returned from agb1500_init( ).
channel Slot number of the slot that installs the SMU to be used. See
Table 2-2.
range Voltage output ranging mode. 0 (auto) or positive value (limited
auto). For the available values, see Table 2-3 and Table 2-4.
start, voltage Start voltage and measurement voltage (in V). See Table 2-4.
Difference between start and voltage must be 10 V or more.
current Current compliance (in A). See Table 2-4.
hold Hold time (in seconds). 0 to 655.35 s, 0.01 s resolution.
delay Delay time (in seconds). 0 to 6.5535 s, 0.0001 s resolution.

agb1500_setIv

This function specifies staircase sweep source and sets the parameters. The sweep
source is used for the staircase sweep measurements and the staircase sweep with
pulsed bias measurements.
For the staircase sweep with pulsed bias measurements, the sweep output
synchronizes with the pulse output by the agb1500_setPbias function.
ViStatus _VI_FUNC agb1500_setIv(ViSession vi, ViInt32 channel, ViInt32 mode,
ViReal64 range, ViReal64 start, ViReal64 stop, ViInt32 point, ViReal64 hold,
ViReal64 delay, ViReal64 s_delay, ViReal64 comp, ViReal64 p_comp);
range, start, stop, comp parameters
Available values depend on the unit. See "Parameters" on page 2-8.
vi Instrument handle returned from agb1500_init( ).
Agilent B1500 VXIplug&play Driver User's Guide, Edition 3
Driver Functions
agb1500_setIv
2-51