Agb1500_Sweeppbias - Agilent Technologies B1500A User Manual

Syntax
Parameters
Driver Functions

agb1500_sweepPbias

agb1500_sweepPbias
This function executes a staircase sweep with pulsed bias measurement by the
specified channel, and returns the number of measurement steps, sweep source data,
measurement data, measurement status, and time stamp data. Before executing this
function, set the sweep source setup and pulsed bias setup by using the
agb1500_setIv function and the agb1500_setPbias function. If you want to use the
synchronous sweep source, execute the agb1500_setSweepSync function.
ViStatus _VI_FUNC agb1500_sweepPbias(ViSession vi, ViInt32 channel,
ViInt32 mode, ViReal64 range, ViPInt32 point, ViReal64 source[ ],
ViReal64 value[ ], ViInt32 status[ ], ViPReal64 time[ ] );
vi Instrument handle returned from agb1500_init( ).
channel Slot number of the slot that installs the SMU to be used. See
Table 2-2.
mode Measurement mode. 1 (current) or 2 (voltage).
range Measurement ranging mode. 0 (auto), positive value (limited
auto), or negative value (fixed range). For the available values,
see Table 2-3.
point Number of measurement steps. Returned data.
source[ ] Sweep source setup data. Returned data. To disable the source
data output, set 0 (NULL pointer) instead of array.
value[ ] Measurement data. Returned data.
status[ ] Measurement status. Returned data. See "Status Code" on page
2-14. To disable the status data output, set 0 (NULL pointer)
instead of array.
time[ ] Time stamp data (measurement start time). Returned data. To
disable the time stamp data output, set 0 (NULL pointer)
instead of array.
2-74 Agilent B1500 VXIplug&play Driver User's Guide, Edition 3