Agilent Technologies 2000 X-Series Service Manual page 10

Figures
10
Figure 24. Removing the power supply shield screw
Figure 25. Unclipping the power supply shield right side
Figure 26. Removing the power supply shield - lift and pull
out 109
Figure 27. Removing the BNC nuts and washers
Figure 28. Removing the top rear deck screws
Figure 29. Removing the bottom right rear deck screw
Figure 30. Removing the bottom left rear deck screw
Figure 31. Removing the bottom rear deck screws
Figure 32. Removing the option module guide to acquisition board
screw 113
Figure 33. Disconnecting the interboard supply cable from the
acquisition board
Figure 34. Lifting front bezel latch
Figure 35. Separating the rear and front decks
Figure 36. Rear and front decks separated
Figure 37. Removing the T6 screws (4 channel version)
Figure 38. Disconnecting keyboard and display cables from
acquisition board
Figure 39. Disconnecting display backlight power cable from
acquisition board
Figure 40. Acquisition board mounting screw locations
Figure 41. Acquisition board removed from front deck
Figure 42. Release the bezel clips from the front deck
Figure 43. All bezel clips released
Figure 44. HINT: When reinstalling bezel, align ground terminal
first 123
Figure 45. Gently lift front deck from bezel
Figure 46. Disconnect the keyboard cable
Figure 47. Disconnect the softkey board cable
Figure 48. Unclip the softkey board from the bezel
Figure 49. Remove the softkey keypad from the bezel
Figure 50. Unclip the keyboard board from the bezel
Figure 51. Remove the keyboard keypad from the bezel
114
115
118
119
123
2000/3000 X-Series Oscilloscopes Service Guide
107
108
110
111
111
112
112
116
116
117
120
121
122
124
125
126
127
127
128
128