Packet Prioritization, 802.1P Qos - GarrettCom Magnum 6K32 Hardware Installation And User's Manual

Garrettcom managed switch hardware installation and user guide magnum 6k32

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

Magnum 6K32 Managed Switch

2.2.6

Gigabit (1000Mbps) port modules

The Magnum 6K32 offered a wide option Gigabit speed with multiple choice

for the modular slot. While up to two Gigabit modules (maxm.) can be configured in the

modular slot. The Gigabit port option for the modular slot comes in couple of different

configuration. The two Giga port has been offered as GBPM-2OTX (fiber or RJ-45),

whereas the single Gigabit module comes in flavor of G+4(10/100 RJ-45 ports) or G+2

(100Mb fiber ports) as shown below in the figure.

ACT

LK RX

1@ 1000Mb Fiber SC + 2@ 100Mb SC

The 6K32 modules provide a GBIC opening for insertion of industry-standard GBICs to

provide Gigabit (Gb) media flexibility. GBIC models are available for both multi-mode

(550m) and single-mode (10, 25, 40, 70)km fiber options, and for Gigabit copper as well,

with new models appearing often.

The 1000Mb Gigabit fiber-port modules on the Magnum 6K32 are normally set

(factory default) to operate at AUTO mode for best fiber distance and performance. The

1000Mbps SC fiber-optic module on the Gigabit -SX and Gigabit-LX transceivers are

compatible with the IEEE 802.3z Gigabit standards.

There are two LEDs mounted on each Gigabit port module. The Gigabit fiber

port is by default configured at AUTO mode, and can be fix at 1000Mbps speed full-

duplex mode at any times and has LEDs that indicate LK (Link status) and ACT

(receiving activity) on that port when lit.

2.2.7