Idbman-4; Iosaclman Messages; Iosdiagman Messages - Cisco Catalyst 4500 Series System Message Manual

Cisco ios system message guide ios release 12.2(37)sg
Hide thumbs Also See for Catalyst 4500 Series:
Table of Contents

Advertisement

Chapter 2
Messages and Recovery Procedures
IDBMAN-6
Error Message IDBMAN-6-VLANMAPPED:Vlan [dec] is mapped to [char]

IOSACLMAN Messages

This section contains the Catalyst 4500 series Cisco IOS ACL management (IOSACLMAN) messages.
Error Message C4K_IOSACLMAN-4-ACLTYPEMISMATCH: Acl RkiosSharedIos[char] was earlier
attached as [char] Acl. Please unconfigure all its uses before using it as a [char]
Acl
Error Message C4K_IOSACLMAN-4-VLANMAPOUTOFMEMORY: Could not add an entry to Vlan Map
[char]. Out of memory

IOSDIAGMAN Messages

This section contains the Catalyst 4500 series Cisco IOS Diagnostic Manager (IOSDIAGMAN)
messages.
Error Message C4K_IOSDIAGMAN-4-CANNOTRUNTESTNOTPORTFAILEDBOOTUP: Cannot run the
diag test as port failed bootup tests
OL-13091-01
The given VLAN was mapped to the specified interface.
Explanation
This is an informational message only. No action is required.
Recommended Action
This message displays if you attach a named ACL as one type, delete the ACL, and
Explanation
configure an ACL of a different type with the same name. For example, you configure a named IP
ACL using the name DefaultAcl, attach it to a router port, and then delete the ACL DefaultAcl by
entering no ip access-list extended DefaultAcl. You could configure a MAC ACL using the same
name. This message is displayed when you try to configure any ACEs in the MAC ACL.
Remove all configurations where the ACL is used as an IP ACL before
Recommended Action
configuring a MAC ACL with the same name.
The system has insufficient memory to allocate a new entry for this VLAN map.
Explanation
Remove all configurations where the ACL is used as an IP ACL before
Recommended Action
configuring a MAC ACL with the same name.
Explanation
The online diagnostic test requested cannot be run on this port because the port failed
bootup tests.
Investigate why the bootup tests have failed on the port. The module or the port
Recommended Action
may be damaged.
Catalyst 4500 Series Switch Cisco IOS System Message Guide
IOSACLMAN Messages
2-45

Advertisement

Table of Contents
loading

Table of Contents