Dot1X-4 - Cisco Catalyst 4500 Series System Message Manual

DOT1X (802.1X) Messages
DOT1X-5
Error Message DOT1X-5-ERR_CHANNELLING: Dot1x can not be enabled on Channelling ports
Error Message DOT1X-5-ERR_VVID_NOT_SUPPORTED: Dot1x can not be enabled on this port
with Voice VLAN configured.
Error Message DOT1X-5-ERR_DYNAMIC: Dot1x can not be enabled on Dynamic ports
Error Message DOT1X-5-ERR_DYNAMIC_VLAN: Dot1x can not be enabled on dynamic VLAN
ports.
Error Message DOT1X-5-ERR_INVALID_AAA_ATTR: Got invalid AAA attribute settings
[char]
Error Message DOT1X-5-ERR_INVALID_TUNNEL_MEDIUM_TYPE: Got an invalid value [char]
for TUNNEL_MEDIUM_TYPE [char]
Catalyst 4500 Series Switch Cisco IOS System Message Guide
2-24
Dot1x could not be enabled on the channelling port. This condition was caused by trying
Explanation
to set Dot1x port-control to auto or force-unauthorized (Force_unauth) mode on a channelling port,
which is not allowed.
Disable channeling on the interface, and then enable 802.1X.
Recommended Action
Dot1x with voice VLAN is not supported on this port on this platform.
Explanation
Recommended Action Remove the voice VLAN configuration on this port and retry the Dot1x
operation.
Dot1x could not be enabled on the Dynamic mode port. This condition was caused by
Explanation
trying to set Dot1x port-control to auto or force-unauthorized (Force_unauth) mode on a dynamic
mode port, which is not allowed.
Disable the dynamic mode on the interface, and then enable 802.1X.
Recommended Action
Explanation Dot1x could not be enabled on the Dynamic VLAN port. This condition was caused by
trying to set Dot1x port-control to auto or force-unauthorized (Force_unauth) mode on a dynamic
VLAN port, which is not allowed.
Recommended Action Disable the dynamic VLAN on the interface, and then enable 802.1X.
The authorization settings obtained are either unsupported or invalid.
Explanation
Change the value to reflect the correct settings.
Recommended Action
The provided TUNNEL_MEDIUM_TYPE is either unsupported or invalid.
Explanation
Change the value to reflect the correct tunnel medium type.
Recommended Action
Chapter 2 Messages and Recovery Procedures
OL-13091-01