Chassis-3 - Cisco Catalyst 4500 Series System Message Manual

CHASSIS Messages
Error Message C4K_CHASSIS-3-CHASSISTYPEMISMATCHINSPROM: Supervisor's FPGA register
chassis type is [char], but chassis' serial eeprom chassis type is [char]
Explanation
chassis' serial EEPROM.
Recommended Action
chassis command. This should never happen in a production chassis. If it does, the chassis needs to
be returned.
Error Message C4K_CHASSIS-3-CLOCKMODULESEEPROMINVALID: Invalid Clock Module seeprom
data
Explanation
should occur only in a prototype switch used in an early field trial.
Recommended Action
switch components for repair or replacement.
Error Message C4K_CHASSIS-3-DAUGHTERCARDSEEPROMREADFAILED: Failed to read the serial
eeprom on module [dec], daughter card [dec]
Explanation
reading this EEPROM is the only way to determine the type of card, the card remains offline, as if
it was not installed on the module.
Recommended Action
module. If this message reappears after you reinsert the module into the switch, the serial EEPROM
might be bad. Contact your technical support representative; you will likely have to return the
module to Cisco to reprogram or replace the serial EEPROM.
Error Message C4K_CHASSIS-3-FANTRAYSEEPROMINVALID: Invalid fan tray seeprom data
Explanation
should occur only in a prototype switch used in an early field trial.
Recommended Action
persists, contact your technical support representative. You may need to return some switch
components for repair or replacement.
Error Message C4K_CHASSIS-3-FIRSTCHASSISSEEPROMINVALID: Contents of chassis's first
serial eeprom are invalid
Explanation
appears in a redundant chassis, which means there is a second serial EEPROM.
Recommended Action
should be returned.
Catalyst 4500 Series Switch Cisco IOS System Message Guide
2-6
The chassis type in the supervisor engine's FPGA register doesn't match the type in the
Check the chassis serial EEPROM information, using the show idprom
A failure occurred while reading the clock module serial EEPROM. This message
Contact your technical support representative. You may need to return some
The serial EEPROM for a daughter card on the specified module is unreadable. Because
Remove the module, and then remove and reseat the daughter card in the
A failure occurred while reading the system fan tray serial EEPROM. This message
Reseat the fan tray to see if the message is due to a faulty connection. If it
The contents of the chassis's first serial EEPROM are invalid. This message only
Try power cycling the switch. If the serial EEPROM is still invalid, this chassis
Chapter 2 Messages and Recovery Procedures
OL-13091-01