Iosiprouteman Messages - Cisco Catalyst 4500 Series System Message Manual

IOSIPROUTEMAN Messages

IOSIPROUTEMAN Messages
This section contains the Catalyst 4500 series Cisco IOS IP Route Manager (IOSIPROUTEMAN)
messages.
IOSIPROUTEMAN-3
Error Message C4K_IOSIPROUTEMAN-3-ADJMANNOMOREADJS:AdjMan:
hardware adjacency resources exhausted, performance may be degraded.
Error Message C4K_IOSIPROUTEMAN-3-FIBCANTALLOCATEFIBADJ:IOS IP Route Manager:No
memory available to allocate FIB Adjacency for [object-info]
Error Message C4K_IOSIPROUTEMAN-3-FIBCANTALLOCATEFIBENTRY:IOS IP Route Manager:No
memory available to allocate FIB Entry for [ip-addr]
Error Message C4K_IOSIPROUTEMAN-3-PBRDOESNOTSUPPORTQOS:Route-map ' [char]
interface ' [char] ' specifies Quality of Service rewriting which is not supported
via Policy-Based Routing on this platform. Please use the Quality of Service
feature instead. This action on the specified route map will be ignored.
Catalyst 4500 Series Switch Cisco IOS System Message Guide
2-50
Explanation The hardware adjacency resources have been exhausted. The supervisor engine will
forward packets to this adjacency in the software. This action will likely represent a significant
performance degradation.
Recommended Action Reduce the number of adjacencies that are loaded into the routing table, and
then clear the IP routing table.
Explanation The switch does not have sufficient memory to allocate space for this adjacency; the
supervisor engine will forward it in the software instead.
Reconfigure the network so that there are fewer hosts that are directly adjacent
Recommended Action
to the Catalyst 4500 series switch, and then clear and reload all of the routes (or reboot) so that the
adjacent hosts that were being sent to the software get reloaded.
Explanation The switch has insufficient memory to allocate space for the route that is associated with
this network.
Contact your technical support representative because memory leaks might
Recommended Action
exist.
The switch does not support QoS services that are implemented using PBR route maps.
Explanation
The PBR route map that is specified will be loaded, but references to QoS services will be ignored.
Use the QoS policy maps and class maps to configure this feature.
Recommended Action
Chapter 2 Messages and Recovery Procedures
' on
OL-13091-01