Hwnetflowman Messages - Cisco Catalyst 4500 Series System Message Manual

HWNETFLOWMAN Messages

HWNETFLOWMAN Messages
This section contains the NetFlow Manager (HWNETFLOWMAN) messages.
HWNETFLOWMAN-3
Error Message C4K_HWNETFLOWMAN-3-NETFLOWSTOPPED:Too many netflow parity errors
encountered. It is very likely that this is bad Netflow hardware. Stopping all
netflow related activities.
HWNETFLOWMAN-4
Error Message C4K_HWNETFLOWMAN-4-HARDWAREUNRESPONSIVE: Netflow Hardware too slow in
responding to software requests
Error Message C4K_HWNETFLOWMAN-4-ERRORADDRS:Netflow Fatal Error Info: Interrupt
Status ( [dec] ),
Addr ( [dec] )
Error Message C4K_HWNETFLOWMAN-4-FATALERRORINTERRUPTSEEN: Netflow Fatal Error
interrupt seen
Catalyst 4500 Series Switch Cisco IOS System Message Guide
2-40
The supervisor engine received too many parity errors from the NetFlow Services Card.
Explanation
The supervisor engine stops all NetFlow-related activities after issuing this message.
Contact your technical support representative.
Recommended Action
Software tried to access NetFlow hardware but there was no response. Typically this
Explanation
would indicate that the NetFlow related hardware may have gone bad.
Contact your technical support representative.
Recommended Action
FDT1 Err Addr ( [dec] ),
Explanation A fatal NetFlow error occurred. The message contains critical information that can help
you determine if the NetFlow hardware is functioning properly or is bad.
Contact your technical support representative.
Recommended Action
The NetFlow Services Card sent a fatal interrupt call to the supervisor engine, which
Explanation
can crash the service card, the supervisor engine, and the entire switch. This condition is extremely
rare.
Contact your technical support representative.
Recommended Action
Chapter 2 Messages and Recovery Procedures
FDT2 Err Addr ( [dec] ), FLD Err
OL-13091-01