Chassis-4 - Cisco Catalyst 4500 Series System Message Manual

Chapter 2 Messages and Recovery Procedures
Error Message C4K_CHASSIS-4-SUFFICIENTPOWERRESTORED: Resuming normal operation
after restoration of adequate power
Explanation
resume normal operation.
Recommended Action
Error Message C4K_CHASSIS-4-TDRTESTINPROGRESS: TDR test is in progress on interface
[char]
Explanation
Recommended Action
Error Message C4K_CHASSIS-4-TESTNOTSUPPORTEDONPORT: [char] is not supported on this
port
Explanation
Recommended Action
Error Message C4K_CHASSIS-4-TESTNOTSUPPORTEDONPORTCONNECTOR: [char] is not
supported on port connector type: [char]
Explanation
type. If the connector type changes to copper, it may be possible to run the test.
Recommended Action
Error Message C4K_CHASSIS-4-UNSUPPORTEDTRANSCEIVER: Unsupported transceiver found
in [char]
Explanation
Recommended Action
transceiver replaced.
Error Message C4K_CHASSIS-7-SYSTEMMEMORYINSTALLED: [dec] MB of system memory
installed. Do 'show platform hardware sdram spd' for details.
Explanation
than one DIMM slot.
Recommended Action
OL-13091-01
The switch reset the modules to conserve power, but it now has adequate power and will
This is an informational message only. No action is required.
The TDR test is already in progress on this interface.
Try the command again after the test is completed.
The online diagnostic test requested cannot be run on the specified port.
This is an informational message only. No action is required.
This online diagnostic test cannot be run on the specified port with the current connector
This is an informational message only. No action is required.
The transceiver was identified as an unsupported non-Cisco transceiver.
If this transceiver was purchased from Cisco, contact Cisco TAC to get the
This tells how much memory has been installed, on supervisor engines s having more
This is an informational message only. No action is required.
Catalyst 4500 Series Switch Cisco IOS System Message Guide
CHASSIS Messages
2-13