Hwportman-7; Idbman Messages; Idbman-3 - Cisco Catalyst 4500 Series Message Manual

IDBMAN Messages

HWPORTMAN-7

Error Message C4K_HWPORTMAN-7-FLOWCONTROLPACKET:Received invalid flow control
packet from [char] da [mac-addr] sa [mac-addr] ethertype [hex] opcode [hex]
IDBMAN Messages
This section contains the interface descriptor block (IDB) management (IDBMAN) messages.

IDBMAN-3

Error Message IDBMAN-3-AGGPORTMISMATCH:[char]:[char]([dec] / [dec]) does match
internal slot/port state [char]([dec] / [dec])
Error Message IDBMAN-3-DELETEDAGGPORT:[char]([dec] / [dec]) Group [dec] has been
deleted
Error Message IDBMAN-3-INVALIDAGGPORTBANDWIDTH:[char]([dec] / [dec]) has an invalid
bandwidth value of [dec]
Error Message IDBMAN-3-INVALIDPORT:[char]:trying to use invalid port number [dec]
(Max [dec])
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
2-40
The supervisor engine forwarded a malformed flow control packet to the software
Explanation
because one or both of the EtherType and flow control/operation code is incorrect. For flow control
packets, the expected EtherType is 0x8808, and the expected operation code is 1 (xoff).
If the devices that are connected to the switch can generate flow control and
Recommended Action
are configured for flow control, verify that the devices can generate well-formed flow control
packets with valid EtherType and operation code fields.
Due to an internal error the software is using an invalid aggregate port.
Explanation
This is an informational message only. No action is required.
Recommended Action
Software is reusing a deleted interface for a new aggregate port.
Explanation
This is an informational message only. No action is required.
Recommended Action
Software is using an invalid bandwidth for an aggregate port.
Explanation
This is an informational message only. No action is required.
Recommended Action
Software is using an invalid port number.
Explanation
This is an informational message only. No action is required.
Recommended Action
Chapter 2 Messages and Recovery Procedures
OL-11541-01