Dot1X-5 - Cisco Catalyst 4500 Series System Message Manual

Chapter 2 Messages and Recovery Procedures
Error Message DOT1X-5-ERR_INVALID_TUNNEL_TYPE: Got an invalid value of [char] for
TUNNEL_TYPE [char]
Explanation
Recommended Action
Error Message DOT1X-5-ERR_MULTI_ACCESS:Dot1x can not be enabled on voice vlan
configured ports.
Explanation
by trying to set 802.1X port control to auto or force-unauthorized (force_unauth) mode on a voice
VLAN-configured port, which is not allowed.
Recommended Action
Error Message DOT1X-5-ERR_PER_USR_IP_ACL: Applied per-user IP ACL was unsuccessful
on interface [char]
Explanation
invalid pub from the RADIUS server.
Recommended Action
Error Message DOT1X-5-ERR_PER_USR_MAC_ACL: Applied per-user MAC ACL was unsuccessful
on interface [char]
Explanation
pub from the RADIUS server.
Recommended Action
Error Message DOT1X-5-ERR_PROTO_TUNNELLING:Dot1x can not be enabled on protocol
tunnelling enabled ports.
Explanation
caused by trying to set 802.1X port control to auto or force-unauthorized (force_unauth) mode on
a protocol tunneling-enabled port, which is not allowed.
Recommended Action
Error Message DOT1X-5-ERR_PVLAN_EQ_VVLAN: Dot1x can not be enabled on a port with
Access VLAN equal to Voice VLAN.
Explanation
the access VLAN and the voice VLAN. This condition was caused by trying to set 802.1X
port-control to auto or force-unauthorized (force_unauth) mode on a voice VLAN that uses the
same VLAN as the access VLAN, which is not allowed.
Recommended Action
802.1X operation.
OL-13091-01
The provided TUNNEL_TYPE is either unsupported or invalid.
Change the value to reflect the correct tunnel type.
802.1X cannot be enabled on a voice VLAN-configured port. This condition is caused
Disable voice VLAN on the interface, and then enable 802.1X.
Dot1x could not successfully apply per-user IP ACL, one possible cause could be an
Reconfigure the RADIUS pub.
802.1X cannot successfully apply a per-user MAC ACL possibly because of an invalid
Examine the RADIUS pub and configure a correct one.
802.1X cannot be enabled on the protocol tunneling-enabled port. This condition is
Disable protocol tunneling on the interface, and then enable 802.1X.
The switch cannot enable 802.1X on the interface that uses the same VLAN number for
Change the voice VLAN or access VLAN on the interface, and retry the
Catalyst 4500 Series Switch Cisco IOS System Message Guide
DOT1X (802.1X) Messages
2-25