Ebm Messages; Dtp-5 - Cisco Catalyst 4500 Series System Message Manual

EBM Messages

Error Message DTP-5-DOMAINMISMATCH: Unable to perform trunk negotiation on port
[char] because of VTP domain mismatch.
EBM Messages
This section contains the Ethernet bridge management (EBM) messages.
EBM-3
Error Message C4K_EBM-3-CANTALLOCATEEBMPORT:No EbmPort memory to allocate EbmPort
for PimPort [char]
Error Message C4K_EBM-3-CANTALLOCATEIENODE:No interposition table memory to add
entry for addr %ea
Error Message C4K_EBM-3-CANTALLOCATEHOSTCHECKPOINTMESSAGE: Cannot allocate memory
for host checkpoint message. Layer2 host redundancy on standby will be out-of-sync
with active.
Error Message C4K_EBM-3-CANTALLOCATEIGMPGROUPENTRY:No igmp group memory to add new
group entry for addr [mac-addr]
Catalyst 4500 Series Switch Cisco IOS System Message Guide
2-30
The two ports involved in trunk negotiation belong to different VTP domains. Trunking
Explanation
is possible only when the ports involved belong to the same VTP domain.
Reconfigure the switch to ensure that the two ports that are involved in trunk
Recommended Action
negotiation belong to the same VTP domain.
There is insufficient memory for information that is associated with the specified port.
Explanation
Install additional memory.
Recommended Action
There is insufficient memory for this internal data structure.
Explanation
Install additional memory.
Recommended Action
There is insufficient memory to allocate space for this internal data structure.
Explanation
Recommended Action You may need to install additional memory in both supervisor engines.
Explanation This error occurs if you have created a large number of IGMP groups and there is
insufficient memory to support additional Internet Group Management Protocol (IGMP) group
entries.
Recommended Action Either install additional memory, or reduce the number of IGMP groups.
Chapter 2 Messages and Recovery Procedures
OL-13091-01