Cisco Catalyst 4500 Series System Message Manual page 83

Chapter 2 Messages and Recovery Procedures
Error Message C4K_IPROUTEMAN-3-FIBLOADBALANCEMANNONEXISTENT: FIB: Attempt to delete
non-existent Load-balance entry with
Explanation
Recommended Action
Error Message C4K_IPROUTEMAN-3-NOMOREK2FIBADJS:K2FibUnicast:no more K2FibAdjs
available, using punt adj instead for [ip-addr] route.
Explanation
in the software instead. The switch performance might be degraded.
Recommended Action
Error Message C4K_IPROUTEMAN-3-VRFMANDUPLICATEVRF: Tried to create a duplicate VRF
for key
Explanation
Recommended Action
Error Message C4K_IPROUTEMAN-3-VRFMANNONEXISTENTDELETION: Attempted to delete VRF
with key
Explanation
Recommended Action
Error Message C4K_IPROUTEMAN-3-WCCPMALLOCFAILURE: WCCP service group [char]
not be setup
Explanation
allocate memory. The traffic that is expected to be redirected by this service group will be routed
normally. This condition might occur under extreme ACL, QoS, PBR, VRF, or other L2/L3 feature
configurations.
Recommended Action
attempting to configure the service group again. Please note that even though the service group
configuration shows up in the CLI, it has failed to be set up in hardware. Therefore, the service group
should be unconfigured before configuring it again. If the above does not help, please contact Cisco
Technical Assistance for further troubleshooting and resolution of the problem.
OL-13091-01
A request was made to delete a non-existent load-balance entry.
This is an informational message only. No action is required.
The hardware resources for adjacencies have been exhausted; switching will take place
This is an informational message only. No action is required.
[object-info]
A request was made to add a duplicate VRF.
This is an informational message only. No action is required.
[object-info] which does not exist
A request was made to delete a VRF that does not exist.
This is an informational message only. No action is required.
for redirection due to memory allocation failure.
The service group cannot be set up for redirection in hardware because of failure to
Try removing the unused or unneeded configuration on the switch before
[object-info]
Catalyst 4500 Series Switch Cisco IOS System Message Guide
IPROUTEMAN Messages
could
2-65