Table of Contents
Advertisement
SIMPLICITY INSTALLATION MANUAL.
12. When all devices have been entered, press Cancel to exit the message editing screen, and cancel again to
exit the menu and to return to normal.
The panel is now configured and ready for operation.
12.2 CONFIGURING THE SOUNDER BASES
On the Simplicity, all detectors are treated as if they have a sounder base during the initial configuration. If a
loop contains a large number of detectors, and a small number of sounder bases, then the sounders might take
a long time (between 4 & 8 seconds) to start.
If this scenario exists, it is possible to speed up operation as shown below. (Note: if every detector has a
sounder base, or if most of the detectors have a sounder base this "speed up operation" will have little or no
effect.
1. Press enter, NEXT, followed by 369 to enter
Configuration Menu 2. Select option 5 to edit device status.
Select a detector that does NOT have a sounder base
attached.
2. Press the Disablement SELECT button. The sounder
symbol turns off to show that this detector no longer has
an associated sounder. (Pressing select again will
continue to toggle the sounder on & off.)
3. Repeat for all detectors that do not have an associated sounder base fitted.
12.3 SETTING TIME AND DATE
To set the time & date, enter Configuration Menu 2 and select Configure System (6). The System Menu is now
displayed. Select option 1 to set time & date. Enter the Day, Month, Year, Hour & Minutes as prompted, and
press enter to save, or Cancel at any time to exit.
12.4 SETTING A CUSTOM BANNER
On the Simplicity, the default screen shows Simplicity 64/126 Fire alarm Panel . But this can be changed to any
2 lines of 20 Characters that are required. In the System Menu, type NaMe (Caps lock,N,Caps lock,a,Caps
lock,M,Caps lock,e). Then type the first line of text, followed by enter, then the second line of text, followed by
enter. This message will now be the screen when the panel is running normally.
Approved Document No: GLT.MAN-107
Issue : 2.00
Authorised: GH
Date: 4/06/2007
Software:PANEL:R1107 & LOOP:R1062
Optical
Analog:
25
Normal
Fl 3 Bedroom 303
Zone:01
Optical
Analog:
25
Normal
Fl 3 Bedroom 303
Zone:01
Ad:016
Ad:016
PAGE 19
Advertisement
Table of Contents
