Zeta SP-64,126 Installation Manual page 17

SIMPLICITY INSTALLATION MANUAL.
Fault Output (FAULT): Gives 24V in the quiescent condition, and 0V in a fault condition. This ensures failsafe
operation even in the event of total power loss. More than one relay can be connected to this output if required.
Typical auxiliary output wiring
FIT BACK-EMF
DIODE ACROSS
RELAY COIL
FLT REP
+
FIT BACK-EMF
DIODE ACROSS
RELAY COIL
+
The termination for the above inputs must be as indicated on the main PCB (See page 31). The Earthing of the
cable screens should be as shown on page 17.
Approved Document No: GLT.MAN-107
Issue : 2.00 Authorised: GH
RELAY
RELAY
Date: 4/06/2007
The fault relay is used to
FAULT
Trigger I/P
INDICATION
connect to a remote
DEVICE
indication device
The fire relay can be used to connect
to various devices which are activated
Trigger I/P
on a fire alarm. Eg. Auto dialer ,
AUTODIALLER
magnetic door release (24V), sprinkler
system etc.
Software:PANEL:R1107 & LOOP:R1062
PAGE 16