Troubleshooting - Dataprobe iBoot-G2+ Manual
Web enabled power switch
Hide thumbs
Also See for iBoot-G2+:
- Manual (28 pages) ,
- Instructions manual (21 pages) ,
- Quick start manual (3 pages)
Table of Contents
Advertisement
The iBoot-G2+ has a recessed pushbutton switch in the event
the unit is not performing as expected. Use the pushbutton as
follows:
Action
Momentary
5 Seconds push
Hold in while and
Power up the
iBoot
V130108E
11.
Troubleshooting
Result
Soft Reset. Will not change outlet
status.
Reset to Factory Defaults. Hold the
button in until the Outlet LED is blinking,
then release.
Recovery Mode. Allows upload of new
firmware to the current IP Address. Will
recover to the Factory default IP
Address 192.168.1.254 if the database
has been corrupted.
iBoot-G2+
Page 33
Advertisement
Table of Contents
Need help?
Do you have a question about the iBoot-G2+ and is the answer not in the manual?
Questions and answers