User Commands - Dataprobe iBoot-G2+ Manual

Heartbeat Commands
get heartbeat
set heartbeat source <none | usb |
network>
set heartbeat port <1-65535>
set heartbeat frequency <1-999>
set heartbeat failcount <1-999>
set heartbeat action <none | on-latch | on-
follow | off-latch | off-follow | cycle>
set heartbeat cycle <1-999>
set heartbeat outlet <main | exp1 | exp2>

User Commands

set user account <yes | no>
set login required <yes | no>
set password <user | admin> <old> <new>
<repeat>
V130108E
These commands are only available to the administrator.
This command displays the heartbeat settings
Status Trigger Count
Source: None OK 0
Frequency: 10
Fail Count: 3
Action: None
Outlet: Main
This command sets the source for the heartbeat.
Either USB or Network
This command sets the port for the heartbeat protocol.
The heartbeat uses UDP and can be the same port
number as DxP, which is TCP
This command is used to set the frequency, in
seconds. How often the iBoot-G2+ expects the
heartbeat
This command is used to set the number of
consecutive failures the heartbeat must detect before
the iBoot-G2+ considers the device to be failed.
This command is used to set the action that the iBoot-
G2+ will perform when the heartbeat detector triggers.
This command sets the maximum number of power
cycles when the heartbeat triggers
This command sets the outlet that the heartbeat will
trigger.
These commands are only available to the administrator.
This command sets whether or not a user account is
used. If <n> only the administrator account is active
This command sets whether or not a login is required
for user level operation. A login is always required for
admin functions.
This command is used to set the password of either
the user or administrator.
iBoot-G2+
None
9100
10
3
None
1
Main
n
y
user
admin
Page 29