Troubleshooting - Dataprobe iBoot G2+ Manual

The iBoot-G2+ has a recessed pushbutton switch in the event
the unit is not performing as expected. Use the pushbutton as
follows:
Action
Momentary
5 Seconds push
Hold in while and
Power up the
iBoot
V110120E
11.

Troubleshooting

Result
Soft Reset. Will not change outlet
status.
Reset to Factory Defaults. Hold the
button in until the Outlet LED is blinking,
then release.
Recovery Mode. Allows upload of new
firmware to Factory default IP Address
192.168.1.254
iBoot-G2+ Page 26