Table of Contents
Advertisement
iBoot-WiFi supports the Dataprobe Exchange Protocol (DxP) for inter device communications and to allow software
developers to integrate Dataprobe product into custom applications. Through the DxP protocol, the developer can:
•
Turn on and off power to the Outlet
•
Pulse the Power On or Off for a specified about of time.
•
Read the status of the Outlet
The DxP Protocol, as well as example code and scripts in a variety of languages are available at
http://dataprobe.com/support-iboot-wifi
The iBoot-WiFi has a recessed pushbutton switch in the event the unit is not performing as expected. Use the
pushbutton as follows:
Action
Momentary
5 Seconds push
Pre-Compliance v180808n
10.
DxP Protocol
11.
Troubleshooting
Result
Soft Reset. Will not change outlet status.
Reset to Factory Defaults. Hold the button
in until the Outlet LED is blinking, then
release.
iBoot-WiFi
Network LED
WPS
Pushbutton
Power Outlet
12 Amps Max
Figure 25 iBoot-WiFi Orientation
Outlet LED
Reset
Pushbutton
Page 21
Advertisement
Table of Contents
Need help?
Do you have a question about the iBoot-WiFi and is the answer not in the manual?
Questions and answers