Dataprobe iBoot-G2+ Manual page 26

Expansion Commands
get expansion
set expansion mode <exp | io | power>
set expansion <exp1 | exp2> link <yes
|no>
set expansion <exp1 | exp2> ipaddress
<dotted decimal>
set expansion <exp1 | exp2> relay <1-8>
set <exp1|exp2> username <20 char>
set <exp1|exp2> password <20 char>
V130108E
These commands are only available to the administrator.
This command displays the current settings of the
expansion ports. The response to this command is
determined by the expansion mode setting.
If iBoot-Exp or Power Control modes:
Link
Exp 1: Yes
Exp 2: No
If Independent I/O mode:
Output
Exp1:
IP Address: 192.168.1.202
Relay: 2
Exp2:
IP Address: 192.168.1.203
Relay: 3
This command sets the mode for the expansion ports to
iBoot-Expansion or External I/O or Power Control
This command sets the Exp1 or Exp2 to be linked to the
main outlet for simultaneous control. This command
takes effect only when expansion mode is iBoot-
Expansion.
This command sets the IP address to send input status
information via DxP protocol to. This command takes
effect only when expansion mode is io.
This command sets the DxP command relay number to
be controlled by input changes from Exp1 or Exp2. This
command takes effect only when expansion mode is io.
This command sets the DxP command username. This
command takes effect only when expansion mode is io.
This command sets the DxP command password. This
command takes effect only when expansion mode is io.
iBoot-G2+
exp
no
Exp1: 2
Exp 2: 3
Page 26