Removing The Battery Latch Assembly - Dell Vostro 1310 Service Manual

Back to Contents Page
Battery Latch Assembly
Service Manual
Removing the Battery Latch Assembly
Replacing the Battery Latch Assembly
Removing the Battery Latch Assembly
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
1. Follow the instructions in Before Working on Your
2. Remove the hard drive (see
3. Remove the WLAN card (see
4. Remove the fan (see Removing the
5. Remove the hinge cover (see
6. Remove the keyboard (see
7. Remove the display assembly (see
8. Remove the palm rest (see
9. Disconnect the cable that secures the internal card with Bluetooth® wireless technology to the system board (see
10. Remove the optical drive (see
11. Remove the system board (see
12. Remove the DC-power module cable from the system board (see
13. Remove the M2 x 3-mm screw from the battery latch assembly.
14. Remove the M2 x 3-mm screw from the alignment bracket.
15. Lift the alignment bracket over the pin and push to the left to remove.
NOTICE: The battery-latch assembly spring is not secured to the latch assembly and can be easily misplaced. When removing the battery latch
assembly, place the spring in a secure location until the latch is ready to be reinstalled.
16. Lift the battery-latch assembly out of the computer and unhook the battery latch assembly spring.
NOTICE: Before you remove the battery release button, observe the orientation of the button to ensure proper installation when the button is
replaced.
17. Remove the M2 washer screw from the battery release button.
Computer.
Removing the Hard Drive).
Removing a WLAN Card).
Fan).
Removing the Hinge Cover).
Removing the Keyboard).
Removing the Display Assembly).
Removing the Palm Rest).
Removing the Optical Drive).
Removing the System Board Assembly).
Removing the DC Power Module).
Removing the Card).