Removing The Display Assembly - Dell Vostro 1310 Service Manual

Back to Contents Page
Display
Service Manual
Display Assembly
Display Bezel
Display Inverter
Display Panel
Display Cable
Camera and Microphone Assembly
Display Assembly

Removing the Display Assembly

CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
1. Follow the instructions in Before Working on Your
2. Remove the hard drive (see
3. Remove the WLAN card (see
4. Remove the hinge cover (see
5. Remove the keyboard (see
6. In sequential order, remove the four numbered M2.5 x 5-mm screws from the base of the display assembly.
7. Remove the captive grounding screw, then disconnect the display cable from the display cable connector on the system board.
8. Lift the display cable and antenna cables from beneath the tabs on the palm rest.
NOTICE: Ensure that the display cable and the antenna cables do not get caught beneath the plastic tabs on the palm rest.
9. Lift the display assembly out of the computer.
Computer.
Removing the Hard Drive).
Removing a WLAN Card).
Removing the Hinge Cover).
Removing the Keyboard).