Hard Drive - Dell XPS M2010 Service Manual

1 SATA data cable 2 SATA data connector (on the system board)
When you connect two IDE devices to a single IDE data cable and configure the devices for the cable select setting, the device attached to the last connector
on the data cable is primary or the boot device, and the device attached to the middle connector on the data cable is the secondary device. See the drive
documentation in your upgrade kit for information on configuring devices for the cable select setting.
To connect an IDE data cable, align the tab on one connector with the notch on the other. When disconnecting an IDE data cable, grasp the colored pull-tab
and pull until the connector detaches.
Hard Drive
Removing a Hard Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
NOTICE: If you are replacing a hard drive that contains data that you want to keep, back up your files before you begin this procedure.
1. Follow the procedures in Before You
2. Remove the computer cover (see
3. Disconnect the power cable and the data cable from the hard drive.
1 power cable
4. Press the blue tabs on each side of the hard-drive bracket toward each other and slide the drive up and out of the hard-drive bay.
Begin.
Removing the Computer Cover).
2 data cable
3 SATA drive