Cd/Dvd Drive - Dell XPS M2010 Service Manual

10. Replace the computer cover (see
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it in to the computer.
11. Connect your computer and devices to electrical outlets, and then turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
12. Enter system setup (see Entering System
CD/DVD Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
Removing a CD/DVD Drive
1. Follow the procedures in Before You
2. Remove the computer cover (see
3. Remove the drive panel (see
4. Disconnect the power and data cables from the back of the drive.
NOTE: If you are uninstalling your only CD/DVD drive and will not replace it at this time, disconnect the data cable from the system board and set
it aside.
1 data cable
5. Slide the drive-release latch towards the base of the computer to release the shoulder screw, and then slide the CD/DVD drive out of the drive bay.
Replacing the Computer Cover).
Setup) and select the appropriate USB for FlexBay option.
Begin.
Removing the Computer Cover).
Removing the Drive Panel).
2 power cable