Hard Drive; Removing The Hard Drive Assembly - Dell 0HRTG Service Manual

About this task
Steps
1. Slide and insert the Solid-state drive into the M.2 port on the system board.
2. Place the thermal bracket on the solid-state drive, replace the single (M2x2.2) screw and tighten the captive screw to
secure the thermal plate to the palmrest.
Next steps
1. Connect the battery cable.
2. Install the base cover.
3. Install the SD card.
4. Follow the procedure in

Hard drive

Removing the hard drive assembly

Prerequisites
1. Follow the procedure in
2. Remove the SD card.
3. Remove the base cover.
4. Remove the battery.
after working inside your
before working inside your
computer.
computer.
Disassembly and reassembly 35