12. Disconnect the solenoid cable from the solenoid card.
1
system board
2
13. Remove the six M2.5 x 8-mm screws that attach the left and right hinge arms to the computer base.
1
system board
2
M2.5 x 8-mm screws (6)
14. Tilt the display forward slightly so the display does not tip over backwards when you remove the computer base.
15. Lift the computer base and carefully thread the solenoid and video cables through the opening in the bottom of the computer base. These cables are
attached to the right hinge arm.
1
video cable
2
solenoid cable
16. Lay the display on its back on a flat clean surface.
solenoid cable
3
solenoid card
3
opening in computer base
3
hinge arms