To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
8. Connect your computer and devices to electrical outlets, and then turn them on.
Installing a Floppy Drive
1. Follow the procedures in
Before You
2. Remove the computer cover (see
3. Remove the drive panel (see
4. Remove the existing floppy drive, if applicable (see
5. If no screws are attached to the new floppy drive, check the inside of the drive panel for shoulder screws. If screws are present, attach the screws to
the new drive.
1
floppy drive
Slide the floppy drive into the drive bay until it clicks into place.
1
drive release latch
6. Connect the power and data cables to the back of the floppy drive.
7. Check all cable connections and fold cables out of the way to avoid blocking airflow between the fan and cooling vents.
8. Replace the drive panel (see
9. Replace the computer cover (see
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it in to the computer.