Wpa(2)-Psk - ZyXEL Communications P-870HN-5xb User Manual

Table 28 Network > Wireless LAN > General: Static WEP Encryption
LABEL
WEP
Encryption
Key 1 to Key
4

7.4.3 WPA(2)-PSK

In order to configure and enable WPA(2)-PSK authentication; click Network >
Wireless LAN to display the General screen. Select WPA-PSK or WPA2-PSK
from the Security Mode list.
Figure 55 Wireless LAN > General: WPA(2)-PSK
P-870HN-5xb User's Guide
DESCRIPTION
WEP (Wired Equivalent Privacy) provides data encryption to prevent
unauthorized wireless stations from accessing data transmitted over the
wireless network.
Select 64-bit WEP or 128-bit WEP to enable data encryption.
The WEP key is used to secure your data from eavesdropping by
unauthorized wireless users. Both the Device and the wireless stations
must use the same WEP key for data transmission.
Only one key can be activated at any one time. Select a default key to use
for data encryption.
If you chose 64-bit WEP in the WEP Encryption field, then enter any 5
characters (ASCII string) or 10 hexadecimal characters ("0-9", "A-F")
preceded by 0x for each key.
If you chose 128-bit WEP in the WEP Encryption field, then enter 13
characters (ASCII string) or 26 hexadecimal characters ("0-9", "A-F")
preceded by 0x for each key.
Chapter 7 Wireless LAN
123