Wpa-Psk/Wpa2-Psk - ZyXEL Communications EMG3425-Q10A User Manual

The following table describes the labels in this screen.
Table 20 Network > Wireless LAN 2.4G/5G > General: No Security
LABEL
Security Mode
Apply
Cancel

9.3.2 WPA-PSK/WPA2-PSK

Select WPA-PSK or WPA2-PSK from the Security Mode list.
Figure 35 Network > Wireless LAN 2.4G/5G > General: WPA-PSK/WPA2-PSK
The following table describes the labels in this screen.
Table 21 Network > Wireless LAN 2.4G/5G > General: WPA-PSK/WPA2-PSK
LABEL
Security Mode
WPA-PSK
Compatible
Pre-Shared Key
Group Key Update
Timer
Chapter 9 Wireless LAN
DESCRIPTION
Choose No Security from the drop-down list box.
Click Apply to save your changes back to the EMG3425-Q10A.
Click Cancel to reload the previous configuration for this screen.
DESCRIPTION
Select WPA-PSK or WPA2-PSK to enable data encryption.
This field appears when you choose WPA2-PSK as the Security Mode.
Check this field to allow wireless devices using WPA-PSK security mode to connect to
your EMG3425-Q10A.
WPA-PSK/WPA2-PSK uses a simple common password for authentication.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
The Group Key Update Timer is the rate at which the AP sends a new group key out to
all clients.
The default is 3600 seconds (60 minutes).
EMG3425-Q10A User's Guide
76