ZyXEL Communications P-870HN-5xb User Manual page 83

Table 15 WAN Configuration: Service Type
LABEL
Rate Limit
MTU
Tag VLAN ID
for egress
packets
Enter 802.1P
Priority
Enter 802.1Q
VLAN ID
Enable IPv6 for
this service
Back
Next
5.6.1.3 WAN IP Address and DNS Server
The screen differs by the encapsulation you selected in the previous screen. See
Section 5.7 on page 95
P-870HN-5xb User's Guide
DESCRIPTION
Enter the maximum transmission rate in Kbps for traffic sent through the
WAN connection. Otherwise, leave this field blank to disable the rate
limit.
This field is not available for an ATM connection if QoS is disabled in the
DSL ATM Interface Configuration.
Maximum Transmission Unit. Type the maximum size of each data
packet, in bytes, that can move through this interface. If a larger packet
arrives, the Device divides it into smaller fragments.
Select this option to add the VLAN tag (specified below) to the outgoing
traffic through this connection.
This field is available when the layer-2 interface is in VLANMUX mode.
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into
a MAC-layer frame that contains bits to define class of service.
Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through
this connection. The greater the number, the higher the priority level.
This field is available when the layer-2 interface is in VLANMUX mode.
Type the VLAN ID number (from 1 to 4094) for traffic through this
connection.
This field is available when the PTM interface is in VLANMUX mode.
Select this option to enable IPv6 for this WAN service so that the Device
can use an IPv6 address when sending traffic through this connection.
You can only enable IPv6 for a WAN service that uses the PPPoE or IPoE
encapsulation method over the ATM or PTM interface.
Click this button to return to the previous screen.
Click this button to continue.
for more information.
Chapter 5 WAN Setup
83