Advertisement
Available languages
Available languages
Installation
Instructions
co0 0L,0 /
STEP
5
Light the Pilots
(fbr models
equipped
with standing
pilots)
The range should
be installed
in its permanent
position
before
any pilots
are tit or adjusted.
Light the Surface
Burner
Pilots
CAUTION:
Make sure the surface
burner
control
knobs
are in the OFF
position
before attempting
to
light the pilots.
1, Paise the cooktop.
2. Light both
pilots with a match°
3. To avoid pilot outage,
use caution
when
closing
cooktop
after lighting
pilots.
NOTE:
Do not leave standing
pilot lit in a newly
constructed
or remodeled
home
or apartment
that wil]
be unoccupied
for more than a month.
Each pilot flame was adjusted
at the factory
to be
approximately
5/16"
(8 mm) tail. A tinge of yellow
appearing
at the upper
tip is normal.
If you find pilot
adjustment
is necessary,
follow instructions
at right.
Adjust
the Surface
Burner
Pilots If Necessary
1. Raise the cooktop.
2. Locate the pilot adjustment
screw, tt can be accessed
through the small hole near the center of the
manifold panel.
3. To adjust, use a blade-
type screwdriver with
a shaft diameter of
less than 3116"
(5 mm)° Turn pilot
adjustment
screw
until pilot is 5/16"
(8 man) high. Do not
reduce the flame to less than 5/16" (8 ram) or pilot
outage may occur. A pilot flame burning higher
than recommended
may generate soot (carbon
black) on the bottom of your cooktop.
Light the Oven Pilot
CAUTION:
Make sure the OVEN CONTROL
knob
is in the OFF position before attempting
to light the
pilot.
1. Remove the broiler drawer by sliding the drawer all
the way out and then lifting slightly to remove it
from its tracks°
2, Locate the pilot at the back of the broiler
compartment.
The pilot is attached
to the left side
of the oven burner.
3. Hght
the pilot with a
match.
No adjustments
are required
for natural
gas. For LP gas, see How
to Convert
the Range
for
Use with LP Gas or
Natural
Gas.
36
Advertisement
