Advertisement
Available languages
Available languages
Clock and Timer
(on some models)
©
[ ,,2:oo]©
(appearance
may vary)
Follow
the directions
below if your range has the clock
and timer shown
above_ You have the choice
of having
the timer show the time counting
down
or the time of
day. In either
case, the timer will signal at the end of
the timer period
to alert you that the time is up.
To
Set the
Clock
NOTE:
_'hen
you first plug in the range or after a
power
failure,
the entire C!ocldTimer
display wilt
light up._
1. Press the CLOCK
pad.
2. Press and hold the UP or DOWN
pad and the time
of day will change
!0 minutes
at a time. To change
the time by single minutes,
give the pads short taps.
3. Press the CLOCK
pad to start the clock,
To Set theTimer
1, Press the TIMER
ONIOFF
pad.
2, Use the UP and DOWN
pads to set the timer.
Short
taps on the UP or DOWN
pad change
the
timers
setting
one minute
at a time. Pressing
and
continuing
to hold the UP pad increases
the setting
ten minutes
at a times
3. Once you have set your timer, press the TIMER
ON/OFF
pad to start timing.
As the timer counts
down a signal will indicate
when
one minute
is left.
After this signal, the display
will count
down in
seconds, When
time runs out, a final signal will sound.
Press the TIMER
ON/OFF
pad to stop the signal,
To Display the Clock While
the Timer
Is Operating
Pressing
the CLOCK
pad while the timer is operating
will not interfere
with the timers
operation;
the display
will change m show the clock, but the timer will continue
to count
down and will still signal when
time is upo
Press the TIMER
ON/OFF
pad again
to change
the
display back to show the timer,
Conventional
Clock
and Timer
(on some models)
The clock and timer are helpful devices that serce
several purposes.
The Clock
To set the dod_,
push in the !mob
and turn it to the right.
Let the
knob out when
the clock hands
reach the correct
time. Continue
turning
the knob
to OFE
Timer
The timer has been combined
with the range clock.
Use it to time al! your precise
cooking
operations.
You'll recognize
the timer as the pointer
that is
different
in color than
the clock hands.
Minutes
are
marked
up to 30, and hours are marked
up to 4 on the
center ring of the c!ock.
To set the timer,
turn
the knob
to the left
without
pushing
in--until
the pointer
reaches
the number
of
minutes
or hours you want to time.
At the end of the set time,
a buzzer
sounds
to tell
you time is up. Turn
the knob
without
pushing
m--until
the pointer
reaches OFF
and the buzzer stops.
To Change
or Cancel
the Timer
Setting
When
the timer is counting
down,
use the UP and
DOWN
pads to change
the remaining
time, or press
the TIMER
ON/OFF
pad to stop the timer_ The timer
cannot
be cancelled
unless you have fully completed
"set timer"
instructions
above.
I2
Advertisement
