Exiting Bios Setup; Using The Utilities Diskette - NEC MC2200 User Manual

Exiting BIOS Setup

To exit Setup, select Exit from the menu bar to display the Exit Setup menu.
The following table describes the options on this menu. Note that ESC does not exit this
menu. You must select one of the items from the menu or menu bar to exit this menu.
SELECTION
Save changes and
Exit
Exit without Saving
Changes
Get Default Values
Load Previous
Values
Save Changes

Using the Utilities Diskette

The utilities diskette contains the SCSISelect Utility and an Event Log Reader Utility.
created by the EXPRESSBUILDER CD-ROM, is not bootable. In
order to use this diskette, you must make it bootable.
To run the Utilities diskette, perform the following procedure:
utilities diskette. This step enables the diskette to be MS-DOS
bootable.
1. Using the EXPRESSBUILDER CD-ROM, create the Utilities diskette.
2. Insert the Utilities diskette into floppy disk drive A. At the C:\prompt type:
SYS A:
Press ENTER. MS-DOS system files are copied onto the diskette. Your Utilities
diskette is now bootable.
3. Reboot the system with the Utilities diskette in
Drive A.
4. The MS-DOS Startup Menu displays. See Table 3-6.
3-12 Configuring Your System
Stores the selections displayed in the menus in CMOS and exits the Setup
program.
Exits the program without saving any changes you have made in this
session. Previous selections remain in effect.
Displays default values for all Setup menus. Useful if BIOS detects a problem
with the values stored in CMOS.
Reverts to previously saved values if the new values have not been saved to
CMOS.
Stores the current selections without exiting the Setup program.
Note: Because of license restrictions, the Utilities diskette, as
Note: Perform Step 2 of this procedure the first time you use the
DESCRIPTION