NEC MC2200 User Manual page 91

5. Remove the filler panel from the system bezel corresponding to the bay where you
are installing a media device as shown below. The filler panel is released by pressing
the plastic snap tabs located on the back of the system bezel. Save the panel for
reinstallation.
Figure 4-17 Removing a Filler Panel
6. Remove the device from its protective wrapper and place it on an antistatic surface.
Record the drive model and serial number in the equipment log.
7. Set any drive jumpers or switches before you install the drive. See the documentation
that comes with the device for jumper or switch information.
Note:
If the drive comes with drive rails, do not use them.
Remove any rails already attached.
8. Attach the device side rails supplied with the system as shown below.
Upgrading Your System 4-25