Specific Problems And Corrective Actions; Power Led Does Not Light; Incorrect Or No Beep Code; No Characters Appear On Screen - NEC MC2200 User Manual

Specific Problems and Corrective Actions

This section provides possible solutions for the following specific problems:
T

Power LED does not light

T
No beep or incorrect beep pattern
T

No characters appear on screen

T
Characters on the screen appear distorted or incorrect
T
System cooling fan does not rotate
T
Diskette drive activity LED does not light
T
Hard disk drive activity LED does not light
T
CD-ROM drive activity LED does not light
T
Problems with application software
T
The startup prompt "Press <F2> key if you want to run Setup" does not appear on
the screen.
T
The bootable CD-ROM is not detected.
Try the solutions in the order given. If you cannot correct the problem, contact your
service representative for assistance.
Power LED Does Not Light
Check the following:
T
Is the system operating normally? If so, the power LED is probably defective.
T
Are there other problems with the system? If so, check the items listed under System
Cooling Fans Do Not Rotate.

Incorrect or No Beep Code

Check the following:
T
Is the speaker enabled?
T
Is the speaker cable connected to the system board?
If the system operates normally, but there was no beep, the speaker may be defective,
contact your service representative for assistance.
Record the beep code emitted by POST, and see "BIOS User's Information, page 5-14.
No Characters Appear on Screen
Check the following:
T
Is the keyboard working? Check to see if the Num Lock light is functioning.
Problem Solving 5-7