Removable Media Devices - NEC MC2200 User Manual

9. Close the front door on the system. If necessary, configure the system as described in
Chapter 3 "Configuring Your System".

Removable Media Devices

A variety of IDE and SCSI removable media devices can be installed in peripheral bays
A, B, C, D, and E. A SCSI CD-ROM is always mounted in bay A. A 3.5-inch diskette
drive is always mounted in bay C. Other devices should be installed in the first available
bay from the top (bay B). Contact your sales representative or dealer for a list of
approved devices.
If you are adding or removing an IDE removable media device, consider the following:
T
The system board supports a primary IDE channel connector which supports two
devices. Your system includes the primary channel IDE interface cable.
T
A first (master) device and a second (slave) device are supported on the IDE
connector. Jumpers on the device determine the device configuration, master versus
slave. Cable Sense (CS) device configuration is not supported.
T
If only one device is on an IDE channel connector it must be set as the master device.
If you are adding or removing a SCSI removable media device, consider the following:
T
The optional SCSI tape drive address assignment is 4.
4-22 Upgrading Your System
Figure 4-14